Navionics plus
Submitted by Tom M on Mon, 2021-12-27 11:58
My navionics map has stopped showing map gradient lines any thoughts on what has happened. Set up in Lowrence.
____________________________________________________________________________
Tom M
.thumbnail.JPG "sundays snapper")
sea-kem
Posts: 14933
Date Joined: 30/11/09
I think you can do a soft
I think you can do a soft reset Tom. What model unit?
Love the West!
Tom M
Posts: 661
Date Joined: 22/09/15
Lcx 27c
Lcx 27c
Tom M
Tom M
Posts: 661
Date Joined: 22/09/15
Thanks googled it and will
Thanks googled it and will give it a try.
Tom M
Shark1
Posts: 1086
Date Joined: 21/05/12
my old hds did it when it
my old hds did it when it wasnt reading the map card propper - cleaned terminals
Tom M
Posts: 661
Date Joined: 22/09/15
Thanks mate will look at
Thanks mate will look at that.
Tom M
Anytime Brad
Posts: 237
Date Joined: 20/07/09
Same problem with mine
Had exactly the same problem with my lcc27c. Thought it may have been the navionics card. Changed the slot the card was in and it then started working so think it may have been a connection issue in the slot.
Try card in the other slot. If still no luck put it in and out a few times or use a little bit of contact cleaner. My card showed no signs of corrosion but you can’t see inside the card slot.
Cheers Brad
I would rather be fishing
Tom M
Posts: 661
Date Joined: 22/09/15
Thanks mate will give it a
Thanks mate will give it a clean.
Tom M