Morning All,

A few years ago, my old man and I made this roof cage for my car. I forgot to make sure my roof racks were in the correct spot when we welded bits of angle on the side (for me to bold the top down to the bottom) and it turns out it was 100mm out on one side...

Shortening a long story, would i able to borrow about 5 minutes of someones time to weld on a new piece of angle? I will remove the old, supply the new, just hoping someone could do a quick weld for me?

Old boy has all the gear but is camping and i am really experienced at blowing holes in aluminum...

I am in Thornlie and will bring this to you. 

Image Upload: